Engineering and Project Management
 

Generators Running at Their Worst Efficiency

Marine diesel generator sets share a property with every heat engine: their efficiency curve is not flat. At low loads they consume disproportionate fuel per kilowatt-hour; at moderate-to-high loads they approach their best specific consumption. The physics is textbook. The fleet reality is not: ships routinely run auxiliary engines at exactly the loads where they burn the most fuel per kWh — 20–30% load, hours at a time, because that’s how the plant happens to be arranged.

The operational pattern is familiar: a vessel at sea runs two or three gensets because one can’t carry the (fluctuating) hotel + auxiliary load alone; a vessel in port runs one engine against a base load that sits far below its optimum; DP vessels run redundancy groups at partial loads by design. Every one of those configurations has a fuel cost hidden in the load factor.

The Arithmetic

The difference between 25% and 70% load on a medium-speed auxiliary engine is typically 15–25% in specific fuel consumption — grams per kWh. That difference, multiplied by auxiliary running hours (which on many vessel classes exceed main engine hours), is a fuel line item that never appears on any report, because fuel is reported by the tonne, not by the kWh at each load point.

The load-management levers are mostly mechanical and operational:

  1. Load-dependent start/stop discipline — running one engine at healthy load instead of two at starving load, with the power management settings that make it possible (the start logic that trusts a single engine when the load says it should)
  2. Peak shaving where the profile justifies — the intermittents (compressors, winches, bow thrusters, cargo pumps) that force the extra engine online for minutes of demand; the engineering question is whether the demand should be managed (staggered starts, soft starters) or supplied (a small peak unit or battery, where the vessel allows)
  3. Waste heat on the auxiliary side — jacket water and exhaust heat from running gensets is fuel already paid for (our jacket-water heat recovery work covers exactly this)
  4. The CII/ETS/GFI translation — every avoided auxiliary tonne is a tonne in the metrics that now price fuel

Where It Gets Delicate

Load management collides with redundancy philosophy: class and DP rules require certain plant configurations, and crews trained to never lose power treat every load optimization as risk. The honest engineering answer is that redundancy is a design question — which configurations are acceptable under which conditions is written in the DP/AMS/UPS design, not in operator folklore. Where the design allows one-engine operation at healthy load, the fuel saving is real; where it doesn’t, the right fix is design review, not operator heroics.

How We Help

Ingeniat approaches auxiliary plant efficiency as mechanical and systems engineering: load profile analysis against the actual running hours, power management philosophy review with class constraints, waste heat integration on the auxiliary side, and the retrofit options (soft starters, demand management, small peak units) that survive an honest payback calculation. This is a quiet corner of ship efficiency — often the cheapest fuel in the fleet to recover.

Related Reading

→ See our energy efficiency optimization service


Your auxiliary engines burn their worst fuel at their favorite loads. Contact us for an auxiliary plant efficiency review.